连接器
简单介绍
所以考虑到施加电压和电阻值的无法动作、线圈温升引起的电阻值的AC型继电器工作的电源基本上都是工频(50或60Hz),作为标准电压
连接器的详细介绍
日本神视连接器NA40-6
由于负载的种类或者各种条件会有很显著的不同,使用时请确认
AC型工作时有冲击电流(在衔铁脱离的状态电阻低,比额定电流大;
在衔铁被吸着的状态电阻变大,为额定电流),所以将多个继电器
使DC型继电器工作的电源有以电压为基准的情况和以电流为基准的情况
以电压为基准情况的标准电压是DC5、6、12、24、48、100V等
有AC6、12、24、48、100、200V。所以如果是标准电压以外的电压时
线圈驱动电源原则上为完全直流。而在含有脉动的情况下虽可在脉动率。
使用环境温度请注意不要超过手册值为10ms以上,请圈上施加额定操作电
There AC6,12. So if a voltage other than the standard voltage
Coil drive power in principle to a full DC. In the case of pulsating
containing although in pulsation rate.
Please note that the ambient temperature should not exceed a value of
more than 10ms manual, apply the rated operating power to the coil
日本神视连接器NA40-6
相关产品
在线留言 |